[shogs92]

My dm11 started to leak out of the back of the lpr so I took a look at the o-ring thats on the lpr seat. If i'm not mistaken the manual says its a #10 ring and they don't come in the parts kit and I haven't seen them in the medium and large part kits on ebay. I'm confused as to which one I need or if its not called an o-ring and they call it something else. I tried to lube the ring a little but then it began to leak out of the screw that is directly below the lpr between the body and the frame. Any help will be greatly appreciated i'm pretty sure I just need to adjust the o-ring. Thanks

[shogs92]

If that wasn't clear enough its the very first o-ring you see when you remove the brass fitting from the lpr.

[grss429]

if its leaking UNDER the LPR meaning the 3 screw holes under the gripframe then it's not the 010 oring, its going to be the 3 orings on the LPR body which are 012's

[shogs92]

At first it was the lpr. Then I lubed it and now it's under the lpr. Was I right about the #10 or is it called a seat?

[grss429]

Originally Posted by shogs92

At first it was the lpr. Then I lubed it and now it's under the lpr. Was I right about the #10 or is it called a seat?

refer to my top post if it's leaking under the LPR it's the 012's,


but if you have extras... go ahead and replace the 010 on the brass adjuster, and if your REG seat (its in the brass screw adjuster) is dented/ looks warn flip it over.

[shogs92]

I understand what your saying but my main question is where to find the 010 ring. They don't come with the gun and from what I can see aren't in any of the parts kits. Thats my main concern. Thanks for your help though I appreciate it.

[grss429]

Originally Posted by shogs92

I understand what your saying but my main question is where to find the 010 ring. They don't come with the gun and from what I can see aren't in any of the parts kits. Thats my main concern. Thanks for your help though I appreciate it.

http://www.ansgear.com/Dye_Proto_Col...edoringkit.htm

ever oring u'd ever need plus colored for easy changing orings are also smoother then black buna ones.

http://www.ansgear.com/ANS_Complete_...m8.9.10.11.htm

same thing but 19 bucks...

http://www.ansgear.com/ANS_Complete_...m8.9.10.11.htm

9 bucks


and the 010 oring wont help you for your leaking if your understanding me.. correctly

and you can also call dye for any orings u need

[iquadra]

If you removed the center set screw while servicing the lpr it can cause a slight leak in between the frame as it broke the locktite seal. From what I am understand by reading your post this is likely the cause.

Go to a hardware store and get some blue locktite make sure its blue and not red! Apply a thin coat to the center set screw and let it sit for a day. Air it up and let me know if this fixes anything, but I had a similar leak (very slight) and it did the trick for me.