Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 07-18-2012, 11:27 PM #1
ETH13
 
 
ETH13's Avatar
 
Join Date: Feb 2012
Location: South Jersey
ETH13 has achieved Level 2 in PbNation Pursuit
Angry Firing assembly problem on ion

Okay. Keep in mind that i have an techt l7bolt in it. So I was taking my gun apart when I stripped where te banjo fitting goes into. he hole is stripped. It is the whole on the swivel donut. So then I took the c clip off of it to replace the swivel donut since it is stripped. I then unscrewed the screw on the back of the firing chamber and the other part of the screw. (on te inside) fell into the firing chamber. When I was trying to get the screw re-screwed, an o ring fell out of the firing chamber but the screw is still stuck in there . What should I do? The firing chamber has a rubber washer in the way so I can not get the screw out that way.
ETH13 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 07-18-2012, 11:41 PM #2
sumsemperfi
the fat guy
 
sumsemperfi's Avatar
 
Join Date: Dec 2006
Location: Shawnee, OK
sumsemperfi has achieved Level 1 in PbNation Pursuit
sumsemperfi has perfected Level 1 in PbNation Pursuit
By rubber washer do you mean the bolt stop? If so just pull it out. Should just pop right out
__________________
THERE IS A FAT KID ON EVERY PAINTBALL TEAM. IF YOU ARE THAT FAT KID, PUT THIS IN YOUR SIG
sumsemperfi is online now   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump