Originally Posted by Screaming4vengence
Promod any chance u could give a walk-through on switching triggers?
There are two ways to do it, one by removing the frame, one by loosening a few extra screws.
Frame On Method
: First off, on both triggers, loosen the pre-travel screw (the one on top) so that it's level with the top of the trigger (so the screw isn't sticking into the marker at all). You can then loosen the two screws on either side of the trigger and swap the triggers. NOTE: When re-tightening the two screws on either side of the trigger, make sure they're tightened equally and that the trigger is centered in the frame (and therefore, not rubbing on the sides of the frame)
Frame Off Method
: Open the right-side grips; remove battery, unplug eyes and solenoid. Then remove the frame (keep track of the two frame orings) and then loosen the two screws on either side of the trigger. Again, make sure the trigger is centered when you're tightening the screws equally. When re-assembling the frame/body, make sure the frame orings are in place and slightly lubed. also note that if you pinch an eye-wire, it'll cause a leak. Just be certain that everything is where it should be before you tighten the frame screws and you'll be fine.