Just figured I'd share a picture of my setup. If you have seen anything by Jeff Dunham the way he says "Sparkly" would be a way to describe that banner.
Jason, Pics of the shaved back cap and the vent mod. Still pending the test. Your vapor going to anno this week. Looks like this anno run is at the end of the week.
Shaved back cap mod
Vent mod. No more air at your hand and outside bolt return adjustable for fine tuning
Back cap drilled for venting air
Also A pic of the blue splash custom
__________________
www.pootypaintball.com = For Custom anno, Ninja tanks, Custom 1-1 Guns, Custom Parts, Factory spares, Rare hard to find parts and upgrades, Gun mods, Lubes and Things
I seem to be running low on time. So if I joined it would suck if I dont post allot. Working for yourself takes a grip of your time. Never a 8 hour day. But if things slow down I would love to join. I am sure I will. My guns..Its just about cool colors and good pics..
__________________
www.pootypaintball.com = For Custom anno, Ninja tanks, Custom 1-1 Guns, Custom Parts, Factory spares, Rare hard to find parts and upgrades, Gun mods, Lubes and Things
No here is what is really weird, so I put the tank in air it up it leaks, shot the gun leaks goes away.
Then I pulled the inlet all the way down to the point the gun will cycle, then slowly crept it up till it fired, the hissing started. Continued up the pressure then it stopped, continued up and then the noid started to leak, backed it down and it stopped all together.
Having not owned a spool in years. Last one was a Gen E Matrix. I would think it is the seals that are in the bolt listed as 9x1BU/70's... I could easily be wrong, and most likely am. Leaking at lower pressure then not leaking then noid leaking doesnt sound wierd. Some seals require air pressure to seal, too little pressure leaks by and too much (noid) pushes by. After it doesnt leak if you let it sit then it starts leaking again?
Having not owned a spool in years. Last one was a Gen E Matrix. I would think it is the seals that are in the bolt listed as 9x1BU/70's... I could easily be wrong, and most likely am. Leaking at lower pressure then not leaking then noid leaking doesnt sound wierd. Some seals require air pressure to seal, too little pressure leaks by and too much (noid) pushes by. After it doesnt leak if you let it sit then it starts leaking again?
No, it doesn't. The thing as well I used at a event and no issues. No leaks, nothing. Then after airing it up to shot in the backyard it started all these issues.
Hopefully pooty or poo can help. I'm not really sure, Haven't had enough time with this platform yet to completely know the ins and outs. Any time I have an issue, I always start with pulling everything apart and doing a full clean, inspect, relube. I have found in the years of playing that solves most problems. Mind you I only have about 3000 balls through my vapor and haven't yet had any issues to troubleshoot.
