Eblade install?? - PbNation
Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

 
Archived Thread - Cannot Edit  
Old 12-30-2003, 10:10 PM #1
cactus_jack
 
 
Join Date: Nov 2003
Location: Northern NJ
 has been a member for 10 years
Eblade install??

One of the holes says you need a 4.1mm drill bit. I have a 4.0mm. Has anyone used anything other than 4.1mm?
cactus_jack is offline  
Old Sponsored Links Remove Advertisement
Advertisement
Old 01-01-2004, 11:40 AM #2
thekoop
 
 
thekoop's Avatar
 
Join Date: Jul 2003
 has been a member for 10 years
It is only a .004 inch difference, I wouldn't worry about it.
thekoop is offline  
Old 01-01-2004, 02:40 PM #3
Dank
The Webb-master
 
Dank's Avatar
 
Join Date: Aug 2002
Location: New England
Dank is a Supporting Member
 has been a member for 10 years
i believe that the eye itself is 4.0 mm and that is why you need the 4.1. you could try it but i dont advise it. you may just want to try to just grind the hole out a tiny bit wider with that drill bit if you have to. I like having alot of tools tho.
__________________
My Feedback
*****

[ East Coast Army ]
*****

NeX
Dank is offline  
Old 01-01-2004, 05:03 PM #4
thekoop
 
 
thekoop's Avatar
 
Join Date: Jul 2003
 has been a member for 10 years
Odds are the drill will "walk" a little and your hole will be a little oversized. It won't drill small so worst case you get a snug fit and best case you get a nice slip fit. Go ahead and drill the hole if its small I'll mail ya a 4.1mm
reamer. I used to be a Toolmaker and I built about a zillion aluminum prototype molds, trust me you will be fine.
thekoop is offline  
 




Posting Rules
Forum Jump