Inoviq 2.5 blinking red/green
Ok, so I have 2 of the Inoviq 2.3 board w/ 2.5 flashed VX chip. This started with only 1 board but now occurs on both. When I first turn them on, instead of blinking red saying that ACE is enabled, they blink red-off-green-off-red, etc. Eyes seem to work, and if you load paint or block the eyes manually they switch to blinking green correctly. But if I disable ACE, it continued to blink red/green, it does NOT go to solid red to show ACE disabled.
Any ideas what in the world is wrong? Like I said, this started on 1 board and then when I was swapping boards to verify if the issue followed the board to my other Quest it then started occuring on the other board, and now happens on either Quest every time.
Manual says nothing about flashing alternating red/green.