We, the engineers at Empire Paintball hid an “Easter Egg” in the software of the Z2
that would allow us to adjust it’s settings, and now I am going to share it with you.
OK, onto the secret sauce...
1) Turn the loader on, have it running but with no paint in it.
2) Push and hold left but then push and hold right button also.
3) Hold for about 5 seconds until the green LED flashes
4) Then release left button first then release right button. You must release the buttons in the correct order. It feels weird at first, but becomes easy after an attempt or two. We made it weird on purpose.
Programming is the same as a prophecy except now left and right buttons functions are switched:
Left (rev) button chooses setting whether you want speed, sound activation, motor sensing or RF
Right(fwd) changes setting value - Press the button the number of times you want the setting
Green is speed and can be set from 1-6
Orange is sound sensitivity and can be set from 1-6
Red is motor sensing and should pretty much be left at the stock setting of 2 (it can only be 1 for off and 2 for on)
Blue is RF and shouldn’t need to be adjusted either. 1 is off 2 is on.
The values aren't the same as the Prophecy. So there are the same number of settings, but speed 3 on the Z2
isn't the same as speed 3 on an original Prophecy.
Originally Posted by Simon
The stock settings are 4,5,2,2 The RF is left turned on because it is "plug and play" with the RF chip when you attach it, but it won't be using any power if the RF chip isn't attached.
turning down the speed will make it gentler.