[Niteflyer]

cant seem to actually understand how to get my velocity jr to fit on this....feedneck has a screw and a washer but nothing to tighten or loosen the neck...it seems like theres no adjusting it...am i missing something?

[bronze]

It should have a screw on the left hand side, this is my closer below. see the stainless screw?

[Niteflyer]

i have the screw....theres no hole on the other side.....so it literlly just sits there...and does nothing

[Niteflyer]

[gamer565]

Your missing the wedge.

[Niteflyer]

does wedge referr to a hex-nut?

[gamer565]

wedge refers to wedge...

[i8somepie]

Originally Posted by Niteflyer

does wedge referr to a hex-nut?

Look inside the feedneck. Are you missing that wedge?

[kadz]

yup you are missing the wedge. Call up blast and get a replacement

[Niteflyer]

am i screwed till then? can i wedge it with something else? have a tourney sunday

[i8somepie]

Originally Posted by Niteflyer

am i screwed till then? can i wind it with something else? have a tourney sunday

Beats me. You could go old school and use something to shim your loader like a piece of cardboard or electrical tape.

But def. call BLAST and get yourself a new one.

[martix_agent]

maybe a piece of wood with a hole predrilled would accept the screw. It may split or warp though.

[Wartortle]

Wrap your feedneck in tape until you can barely wedge it into the feedneck then don't touch it..

[kadz]

Originally Posted by Wartortle

Wrap your feedneck in tape until you can barely wedge it into the feedneck then don't touch it..

I agree do this. I lost the wedge on my rapper but the feednech is so tight that my rotor stayed in just by the pressure alone with no wedge.