[ApocSin]

Okay guys so, Last week my gun started leaking air really bad. Seemed like it was coming from the bolt. Well Stupid ME put the Poppit in backwards. so ok dumb move. Fixed that issue. But than...the leak stopped but my gun would not fire. WTF. so i checked the reg. checked everything. cleaned everything re-lubbed everything. Nothing! WTF! so I had a DYE hyper 3 Regulator that I ordered allready at my parents house waiting for me to pick up. So I picked that up installed it and....WOOOSH! HUGE LEAK! made sure poppit was in correctly it was. fiddle around with it get the huge leak down to a medium to small leak. Friend suggested i fire the gun...Pull the trigger I hear the noid kick over but NOTHING! fine....so I put the stock reg back on...Leak is still there Pull the trigger the gun fires...still leaks....Put the gun upside down to turn it over Leak stops.....Still fires correctly. BUT Bolt wont go all the way back. Pull off stock Regulator put on Dye Reg, Still leaks...Wont Fire....Turn it upside down...still leaks... Wont Fire.....BUT this time the leak doesnt seem to be comming from the breach it sounds to be comming from the hand grips???? or at least Right above them....Pull the trigger....Hear the noid...no shot. My ram is fine...my bolt is a little worn i have a new one on the way...so WTF is the problem?!!? Im at my wits end with this gun! Luckily I have a Planet Eclipse Geo 2.1 On the way. So anyway Any suggestions on the FX?

EDIT: Just Fixed some spelling mistakes.

[Paper_Cut]

Wow, you ****ed it up hardcore. Have you tried disassembling the solenoid and replacing the Orings?

[basementN3k0]

i'm pretty sure you're going to **** away the Geo as well. it's not the gun, it's the owner. you either ****ed the poppit, cup seal, or you have to clean the noid and regulators. i'm pretty sure it's your orings.

[disturbed989]

Is your noid seated correctly against the body? Start there and if it still leaks after that then change the ram o-rings?

[Paper_Cut]

Originally Posted by basementN3k0

i'm pretty sure you're going to **** away the Geo as well. it's not the gun, it's the owner. you either ****ed the poppit, cup seal, or you have to clean the noid and regulators. i'm pretty sure it's your orings.

If you can **** up an FX the geo is going to be childs play. The Geo is easy to mess up and hard to fix. It is a blowforward and pretty much a G3/G4. So, any problems they have you'll have with the Geo plus a few more from that dicked up leak machine they call a solenoid.

[AoSpades]

my suggestions:

• New ASA
• New Macroline fittings
• New Solenoid
• Gun Grease
• Common sense on how to disassemble and reassemble a paintball marker
• Sentences, proper grammar and spacing. It goes a long way.

Well hop to it.

By the way, good luck with that Geo 2.1, there are several other CHEAPER markers out there that can outperform it on every level.

Been there, shot that. Not worth ~$1200.