[DangerousPaur]

I screwed my compressed air tank into my g4 and I'm at the field and it is leaking out the tube from grip to regulator! I need help please I'm at the field with no gun

[justicexd]

Is it leaking from the threads, swivel, or around the macroline? If it's leaking around the macroline then you might need to change the oring inside the fitting. To change the oring you need to remove the macroline and retainer clip from the fitting and reach inside with a pick to remove it...the oring is a 010.

[AoSpades]

The macroline is leaking? or is the macro fitting leaking?

[buckeye_man18]

Tighten the macroline fittings, add a small drop of oil to the macroline fitting o-rings (on inside), make sure macroline is cut to the right length so it doesn't have to bend or stress when hooked-up, and that ends of the macroline are flat. Might have to just replace the macroline fittings - the DP ones suck

[DangerousPaur]

Ok so I cut the macro line a bit shorter and it worked but then it started again. I am going to get some new fittings and possibly macro line. Any recommendations?

[buckeye_man18]

Macroline probably not the problem unless it's too short.

Any macroline fittings other than DP or cheap off-brand fittings will be fine.

[DangerousPaur]

What are some good fittings I could choose from?

[Darkh2o]

Ninja Paintball makes some great fittings!

[Whitie22]

Is the leak from the reg or the transfer tube.? Might need to relube the reg.