[GhostJedai]

So, yeah, I'm a little late into this thing, but I'm wondering if there's a good alternative to the Flasc Single trigger upgrade, since I'm not a fan of the stock trigger setup.

Anyone? Bueller?... Bueller?...

[GhostJedai]

I actually talked to the guy at FLASC and he informed me that the triggers aren't discontinued, but rather KEE stopped selling him the trigger magnets, and the stock magnet screw is too long.

Also, the stock trigger guard is a bit too thick (by 2mm, if I recall), which stops the trigger short.

So, if you want an aftermarket trigger, you'll have to cut down the screw, buy the APE board, and then shave the trigger guard down (or mill your own).

[TheEnglishGuy]

If you buy the APE board then it comes with a custom screw, so you wouldn't need to cut anything down. Also you can either shave down the trigger guard or the tip of the trigger itself.

English

[GhostJedai]

Oh, I know. I was planning on shaving the trigger guard down until I can just make my own. Luckily, I know a guy with a machine shop