[KyleSchenk]

anybody know where i can get a new template or link to a site with the measurements of where to drill the eye for an eblade?

[Aglar]

A template is supposed to come with the e-blade, as far as I know. Unless you bought it used or something.

[KyleSchenk]

long story but yea i dont have the template

[BOOBOO6119]

I can fax you one if you have a fax... lmk BOOBOO6119@aol.com

[peacemaker]

if u go to eclipses website www.planeteclipse.com and go to tech or something one of the manuals is for the eblade and requires adobe reader to view it, i am pretty sure it has the exact same things as they are said in the manual that comes w/ the eblade

[KyleSchenk]

Thanks everyone, i got the exact measurements form Jakel at g3pb.

[Longshot22]

What are they?

[KyleSchenk]

straight for jackal himself, From the bottom of the body 1.5" to the centre of the bolt bore. From the back of the body, 4.215" to the centre of the feed. Drill 4.1 mm hole for the eye. Move .200" toward the feed tube and drill and tap for a 4-40 screw. You don't need a templet. If you are trying to do this on something other than a mill and that is why you want the templet, I strongly advise against that. If you are off the eye will not read properly.