CCM fitting leak help

Josh.Smith · 02-22-2012, 08:58 PM

The o-ring on the inside of my CCM fitting is leaking. How do I get it out? I looked at the manual break down and couldn't figure it out...

jesus01 · 02-22-2012, 09:10 PM

you have to pull the collet out of the fitting and then the oring just pops out. i put two orings in there and it made the fit real tight but no leaks ever now.

Zepulkinator · 02-22-2012, 09:28 PM

Yeah jesus01 is right, this also applies to regular fittings if you can't get the leak to stop.

Josh.Smith · 02-23-2012, 06:17 AM

Basically, my question is:

How do I get the collet out?

Methods, etc...

Nahib_Stilgar · 02-23-2012, 09:57 AM

take the fitting off the gun and it should just pop right out.

double up the orings on both fittings. never had an issue since i did that

bokyo102 · 02-23-2012, 09:57 AM

http://www.pumpenstein.com/manuals/C...Kit_Manual.pdf

to take out the collet, just use any flat head screw driver or even a butter knife,

bokyo102 · 02-23-2012, 10:10 AM

CCM CHICK · 02-23-2012, 02:44 PM

You can call us direct and we can help you as well.

M-F 7am to 3:30 pm pst
1-877-412-6850

BIG BOB · 02-23-2012, 05:38 PM

I went with double 09 o-rings on my reg and on/off just to be sure that they would never leak.