Azodin Reg and ZERO setup
Hey guys i thought I'd post what i found to be the best settings on the azodin OEM reg and the ZeRo system.
This is on a Zenith.
on the regulator 4.5 full turns out (counter-clockwise) from soft bottom out. This will give you approximately 250psi output. (as per the manual each quarter turn is equal to 25psi) so adjust as needed.
You need to check your gun with a chrono before play!
I usually tweak the reg till im shooting 280FPS and use the main spring tension to set to 295 FPS.
I contacted Azodin directly for the ZeRo factory settings.
With the set screw flush with the front of the ZeRo system 3 full turns in (clockwise). THIS IS THE SETTING FOR HPA.
Hope this helps anyone that did a full tear down and needs to re set everything.