Originally Posted by pbcustom98
remove it from 98c #1, and then install it in 98c#2.
the only part i am not sure of is:
the piece you pop out for the banjo fitting, does that need to be capped off?
Yeah, I was thinking the same thing...As far as I know, you just disassemble the halves of the marker, pull the RT out of the first one and hook it up onto the other one. I think the banjo doesn't matter because the RT runs off of blowback gas and should only be a problem when the hammer lines up with the hole. Correct me if I'm wrong, but I don't think you need a cap for the banjo bolt.