ok so now i got the new solenoid in my marq. now when i air it up it will shoot once at about 270fps then the second shot is around 150ish fps. and after the second shot it wont fire anymore but i can still here the solenoid click? what else could be the issue? i used my pressure tester and set my pressures to stock and i made sure the are no orings in that last slot. i also have all three holes aligned. sorry for being such a pain in the ***.
edit: also after it stops shooting i can degas it and re air it up and it will fire twice then stop again.
__________________ Reverse Poison 2K12 Bob Long G6R DP G3 Spec r W/ Techt Bolt Engine, VP Deuce Trigger, and a 7E OLED Board
2K2 Vert. Feed Autococker W/ CCM Pump Kit and Gat Products A/T
Could be the poppet valve on it or an o-ring on the valve. Time to do a rebuild if you haven't done one already.
Worst case I would think it would require replacing the valve itself. Maybe could be time to consider a super charger in an extreme case if you can't get parts or solve the issue.
I had this issue once , depending on the lube you used ( which should be Dow 55 per BL Manuel ) and also how much can determin this. Check the little o ring in the back cap, if it is to lubed it will not seat after first shot is fired and causes the bolt to act as if it is stuck.
Sorry for the word block but I do hope this helps. I ran into this issue last weekend I changed the battery and went to Stock settings as well.