Rebuilding my Rock lpr...

NargofWoV · 12-15-2011, 09:54 AM

Took it apart, no problem, changed the larger two o-rings pretty evident, cleaned it up, however... In the re build kit are two smaller o rings, where do these go? I can't find the location of these two much smaller O rings?

The fitting between the body and the LRP, does it come off? Are there O rings in there?

Bobtheballer · 12-15-2011, 10:21 AM

I've never taken a full size rock apart. But the the fitting that screws the LPR onto the gun also comes off and there is a small piston and an O-ring in there

NargofWoV · 12-15-2011, 10:54 AM

Ah hah... Now, off to buy a strap wrench to take that goofy thing apart...

Reddawg · 12-15-2011, 04:23 PM

If like most regs there is one under the spring where the smaller shaft goes through. Just above the reg seat. Pull piston and spring should be a washer and under that is the small o-ring.

Rebel_816 · 12-15-2011, 05:39 PM

http://customcockers.com/forum/showt...PR-(Full-Sized)

heres a how-to, hope it helps

NargofWoV · 12-15-2011, 09:15 PM

Quote:

Originally Posted by Rebel_816

http://customcockers.com/forum/showt...PR-(Full-Sized)

heres a how-to, hope it helps

Na, that is as far as I went with out finding the two small O rings that came in the rebuild kit. The part that is left ON the reg in that picture, I'm thinking, must contain those two O rings. I believe that's the part with the small pin that moves in and out.