[tschulz]

i have an nt11 with a virtue oled board. I was told that the stock settings should have the marker shooting good, however when i did a board reset back to stock, the OLED board displayed a dwell of 6, and the marker would not fire. I really like the board, and do not want to go back to stock, but all of the setting seem so messed up even at stock, the marker either fires terribly or not at all. if you have one of these boards, what are the settings you are currently using to produce a smooth shot with minimal kick? thank you for help in advance.

[wesr]

start at the nt11 manual setting of 9... most people use 10 or 11

[tschulz]

thank you. so adjust dwell,and leave all other settings stock? i received the nt111 with the virtue oled board already in it. It has been very difficult to deal with. I do not like to tinker with my markers. can someone please suggest the smoothest possible settings for a nt11 with virtue oled board?

[SmartWorrPartsPlayer]

Ok smoothest set-up. First start with the basics; Clean/Re-Lube Your Bolt Assembly. Make sure your 017 O-ring in the Beer Can is good. Also check that your 014 and 012 O-rings on the Plunger are good, those 2 specific O-rings is what controls that Bolt in motion.

Next, have the Green Tip Bolt Insert, NO Spacers.

NT10 Dwell @ 8-10ms
NT11 Dwell @ 9-11ms

Also, you could do the Billy Wing Mod, which is you take a piece of Macro-Line and cut it to fit around the Stem of the Spool. Which reduces the volume of air that has to occupy the space to move the Spool.

I have this exact Set-up with both of my NT's and they are Super Smooth, and Efficient. I'm getting 4 Pods and a Dye Rotor, off a 1.2K psi.

[tschulz]

so 8-10 on the virtue board? because arent the settings weird on the virtue board when compared to the stock nt board? for example a dwell of 7 on the virtue oled board does not equal a dwell of 7 on the stock nt board? i asked virtue, and they told me to do a board reset, and leave it alone, because they have programmed the best setting for that particular gun in there, but the dwell has a stock value of 6 on my oled board, and will not fire.

[Paint_hore]

or you could search, there are a few threads on the subject.

[SmartWorrPartsPlayer]

Well you have an OLED Board, so it says on the board what exact Millisecond you're at.

*Correction on my last post*
Dwell Setting is for the NT10, NOT NT11.

Just to clarify.

Stock NT11 Dwell is @ 9ms, so you can adjust between 9-11ms of Dwell on the NT11.

[tschulz]

paint hore, every post i have seen that has been close to this, has not answered my thread, and all you do is come on here and tell people to search, in the amount of time it took you to find my thread, and click on it, you could have just helped me, all im asking for is a little help from people whoo are more knowledgeable than me on this subject,

smartworrpartsplayer- thank you again, you have helped me multiple times, and i appreciate it.

[Paint_hore]

...and in the time it took you to make a thread you could have found the answer yourself, yes/no?

[Paint_hore]

oh look how hard it was to type OLED into the search and come up with an exact match WITH NT11 OLED SETTINGS IN IT.

http://www.pbnation.com/showthread.p...highlight=oled

I just noticed that you posted in that thread just yesterday ffs.....