Ok smoothest set-up. First start with the basics; Clean/Re-Lube Your Bolt Assembly. Make sure your 017 O-ring in the Beer Can is good. Also check that your 014 and 012 O-rings on the Plunger are good, those 2 specific O-rings is what controls that Bolt in motion.
Next, have the Green Tip Bolt Insert, NO Spacers.
NT10 Dwell @ 8-10ms
NT11 Dwell @ 9-11ms
Also, you could do the Billy Wing Mod, which is you take a piece of Macro-Line and cut it to fit around the Stem of the Spool. Which reduces the volume of air that has to occupy the space to move the Spool.
I have this exact Set-up with both of my NT's and they are Super Smooth, and Efficient. I'm getting 4 Pods and a Dye Rotor, off a 1K psi.
If you have any DM or NT questions feel free to PM me.
Also provide Maintenance/Cleaning/Tuning of Dye Markers.
Dynasty WhiteBlue Geo2.1
FS CHEAP VAMPIRE Bob Long Ripper Victory
Last edited by SmartWorrPartsPlayer : 10-18-2011 at 12:50 PM.