Originally Posted by gamer565
Probably cause you don't have the new updated pin.
I convinced BLAST to send an updated pin and it didn't help me much...
I've cut the original brown oring and one buna on the new pin since getting it. I'm using a LP Ninja (all shims removed), lubing the orings with dow33, and always leave the air on all day. I'm very careful when turning it on/off... when turning off I go slow until I hear a slight hissing, wait then go a bit further, etc. This seems to help somewhat and I don't seem to be cutting the oring as often, but I'm pretty sure it is only a matter of time. It must be a machining issue and not all ASAs have the problem as severe as others.