|
Troubleshooting
Just took my B2K out of storage, cleaned and oiled it, but when I gas it up the bolt goes back but it will not cycle.
So far I have tried:
New 9V
Reassembled to insure that I did not put something in backwards
Pressure is good going into the LPR
Unfortunately I ran out of air before I could continue trouble shooting. The LPR (Microrock) was leaking heavily out of the adjustment screw but I ran some oil through it and that fixed the major leaks.
Any suggestions on the marker not cycling? I don't hear the solenoid clicking (can't remember if I should).
|
