[HKArmyKid219]

My Epiphany is not firing. I air it up, and when it does shoot it chronos 300+. Would lowering my velocity help? I mash the trigger and it only fires like 1 out of every 10 pulls or so. Would it help if i took it apart and lube and oil everything?

[iSkiM-321]

it wouldnt hurt to take it apart and oil everything...

[theblindchicken]

velocity should be lowered a little via the hex adjustment on the bottom of the reg (if stock reg) and then to check your dwell and ROF delay settings. your delay may be too high that doesn't allow your trigger to detect each pull. Also, pull the trigger back slowly and listen carefully to make sure that the microswitch is clicking before the trigger screw taps the frame. If there isn't very much of difference between the click and the tap, then that will cause a problem.

I had my trigger set as close as possible, but only 2-3 out of every 5 shots actually fired. If you have any other issues, feel free to reply or PM me.