I just finished putting all of the parts that come on the NT11 and not on the NT10 into my NT10, apparently all of the parts that were upgrade for the NT11 fit and work perfectly into the NT10 (noid manifold, bolt insert, and several parts on the bolt). I called up dye when I broke my old bolt and go into a 30 conversation with one of their phone reps about the differences between the two guns. My NT10 (10.5
) is shooting smoother and quieter by far now, total cost before shipping was around $100. Look into this before you buy an NT11 for sure.
PLEASE STOP PM'ING ME AND ASKING ME ABOUT THIS!
! I no longer have my NT, and you can find every answer to the dozens of questions i have been pm'd by browsing through the first 3 pages of this thread.
The 2 most asked questions:
Q: Where do i get the parts?
A: Call Dye and talk to a sales representative.
Q: How much does it cost?
A: if you buy all of the parts listed including the o-rings and bumpers it will be between $150 and $200, that is what I remember paying.
PARTS TO BUY AND REPLACE:
1. Spool (if you don't have a parts kit you will need to ask for a black bumper and an orange bumber for the spool, the spring is the same and can be swapped out)
3. bolt (part that makes contact with the ball, bolt tip if you want to call it that, manual calls it "bolt")
4. spacer rod
5. MAKE SURE TO BUY a 015 o-ring, the NT10 doesn't use them but the NT11 does, it is the o-ring that will replace the brown 016 o-ring on the bolt (the part that physically pushes the ball out)
1. Solenoid manifold (only the manifold, they can be swapped out)
2. greet bolt insert