[i got money that blo]

i took the gun apart(took of the grip frame) and now when i air up the gun nothing happens, no air get to the bolt(it seems like) and it wont dry fire or anything. its not a battery problem, i know that for a fact.

[herk8240]

All you did was take the grip off and it won't air up? Why'd you take off the grip? Did you do anything to the hpr/lpr/asa?

[i got money that blo]

Originally Posted by herk8240

All you did was take the grip off and it won't air up? Why'd you take off the grip? Did you do anything to the hpr/lpr/asa?

i have two vic's and i wanted to change color scheme, so i tried that out, and it didn't quite work out so i put them back together. i took the asa apart, on 1 of them, and then put it back, im pretty shure nothing wrong with the asa, cause i aired it up right after i put it back together, and it shot fine.....but i went to a tourny this sat, and it didnt work

[Booyahkai]

check and make sure the pin for the asa is still there.

[Steve1gbr]

Originally Posted by Booyahkai

check and make sure the pin for the asa is still there.

This and assuming it is there check that turning the cam moves the pin as it should.

[jballer08]

Had Something Like That Happen But Moved The Pin And It Was Fine

[zzcn]

you can remove bolt and air it up
if it will leak as hell from the holes under the bolt then it is aired up... and its not a tank/asa problem

try to shoot holding trigger for 2 sec to check if its eyes or not
else I think it could be noid/reg trouble (not correctly installed etc) or a blockage ...
else try to reset board and get a new battery and make sure back screws at the back of your bolt tightened

[paintking22]

To diagnose the problem you should remove the bolt and air it up and if leaks then you know it is not the asa or the regulator. If air does not come after you removed the bolt, my guess would be the regulator was put back together wrong.

[specopsdeath2]

why are you bringing up dead threads?