[AnDr3w22]

The inline reg on my nerve starts to leak out the bottom of the reg whenever it goes over 200 psi. This is pretty troublesome for me because At 200 psi I'm only able to achieve velocities of about 240 fps. Any ideas on what could be going wrong?

[shadowlord06]

Might need to replace the orings in the reg or maybe just tear it apart and lube it up good.

[jim4130]

Copied from zdspb.com

Leak from the bottom of the vertical regulator (adjustment endcap). Leaks out the adjustment endcap can appear gradually after you fire a shot or be a constant leak of pressure. Same problem for both of these. The following seals can cause this symptom, and should be cleaned. · Piston o-ring (14/75); clean and regrease. · Base seal between the poppet and the base (flared section of the poppet and the opposing surface); clean with no grease. · Base seal 12/90 o-ring; clean with no grease.

[AnDr3w22]

Thanks. I checked on zdspb but I probably over looked it. Will work on it this weekend.