Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 02-10-2011, 01:25 AM #1
Slow Z Rally
 
 
Slow Z Rally's Avatar
 
Join Date: Jan 2011
Universal T-board?

Anyone out there UTB'd their BKO's? Just picked one up and was thinking about trying to pull that one off.
Slow Z Rally is offline   Reply With Quote
Old 03-05-2011, 09:55 PM #2
peachesarenottasty
 
 
peachesarenottasty's Avatar
 
Join Date: Jun 2009
Location: EsconGhetto, Ca
peachesarenottasty is playing at Living Legends III
peachesarenottasty supports Team VICIOUS
peachesarenottasty supports Pev's Paintball
peachesarenottasty has achieved Level 3 in PbNation Pursuit
i think you can. The noid should operate at the same wattage, it's a humphrey and I think it was 5v or something similar, I don't remember wattage though, I just sold my bko so I'm unsure. It should be pretty much a drop in replacement though since all the wires are all ready in the body, the bored plugs into a harness. So all you should need to do is remove them from the molex connector and solder them to the t-board.
__________________
peachesarenottasty is offline   Reply With Quote
Old 03-06-2011, 02:36 PM #3
ICdzBuff
PL Mogul
 
ICdzBuff's Avatar
 
Join Date: Feb 2010
Location: Cincinnati, Ohio
ICdzBuff supports Team VICIOUS
ICdzBuff supports Sherwood Forest
ICdzBuff supports Sherwood Forest
ICdzBuff posts videos on PbNation
ICdzBuff is an NCPA player
ICdzBuff supports Pev's Paintball
ICdzBuff has achieved Level 4 in PbNation Pursuit
Worst case scenario, the board comes with a capacitor for the noid, so wattage shouldn't be an issue. I personally don't like them, just pick up a chaos or something.

But to answer you question, no, I have not seen it done, but it will work.
__________________

63 ICD Bushmasters \/ Moderator ICDO \/ Feedback ICDO

ICdzBuff is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump