[Loony]

What must I do?

Without that extra little lip on the tip of the ram what can I do to make up for it? Can I up the LPR pressure a lot higher? How high can it go?

Any ideas?

I've had the ram sitting here looking at me for a few months now and I still can't figure it out.

[tjs0349]

Changing the LPR pressure isn't going to make up for the missing tip on the ram. The Necroram and Eigenram (Lurker) were not desinged for the NME. The NME is very similar in design to the Intimidator which both rams were designed for. Due to this, both rams will fit in the NME, but will not work properly no matter what settings or pressure you use.

You have two options.

Option 1: Modify the tip of the Necroram to work with the NME ram sleeve and poppit. There are a number of ways this could be done.

Option 2: Install an Intimidator ram sleeve and poppit in your NME. This will allow either the Necroram or Eigenram to work as they were designed for the Intimidator.

[Loony]

Any ideas on what I could do to the tip of the ram?

I was thinking of drilling into the tip and inserting something in there; not sure if I can without compromising the material.

Which poppet and sleeve do I need? Gen4? Alias?

[tjs0349]

Drilling into the tip of the necroram and adding a small screw to replicat the tip on the NME ram, or something to that affect would probably work.

Alias or 2k2 ram sleeves should work. Standard Intimidator ram sleeve/poppit rules apply; match ram sleeve and poppit.