Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 11-16-2010, 07:03 PM #1
blade_x23's Avatar
Join Date: Mar 2006
Location: Chilliwack, BC Canada
 has been a member for 10 years
ACP Delrin VS Teflon

ACP Delrin Vs Teflon bolt, which is better? Why get one or the other? What are benefits of both? Was lookin at gettin a ACP bolt but not sure which one to get. Also is it worth it to get the low blow bolt or does it cause alot of inconsistencies?

Side Question:

Is there any aftermarket ball detents for the Wrath? Like Kila detents or something?
Ego 06
Modded Cure3+ bolt, CP Feedneck, Violent Trigger, Ti Rammer, Hybrid Ram Cap, Bob Long Cam Drive, Virtue Eyes & OLED Board, Kila detent/eye covers, Hybrid grips, Lucky Uni1tec kit, 72/4500 CF Tank, Halo
Diablo AR-1
Mostly stock, Kalld Trigger, CP 2008 On/Off, Virtue board, steelie tank, Pinokio
Dragun T1
Mostly Stock (converting to clamshell), Evil Timmy Frontblock w/ AKA SCM LPR, Powerlite Scepter kit, steelie tank, Vlocity Jr.
Piranha EXT Pro 2K3
ACP DelFlo Bolt, NDZ Spyder Valve, Hybrid Hedloc 2, Bob Long Torpedo, Old CP On/Off + Rail, Eforce Frame, PE Metal Trigger, SP Progressive, CO2, VL Revy
blade_x23 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 08-20-2012, 10:51 PM #2
mexi ca40k
Pump Playa
mexi ca40k's Avatar
Join Date: May 2011
Location: North Vancouver
mexi ca40k is playing at Living Legends V
mexi ca40k is for the Gunfight
mexi ca40k is for the Gunfight
mexi ca40k supports Pev's Paintball
mexi ca40k has perfected Level 1 in PbNation Pursuit
mexi ca40k has achieved Level 3 in PbNation Pursuit
mexi ca40k is attending Decay of Nations VI
I personally don't think its worth upgrading the bolt, i have heard that it doesn't do very much.
mexi ca40k is offline   Reply With Quote
Old 08-21-2012, 07:51 AM #3
Broke but never broken
tacxplosion's Avatar
Join Date: Sep 2007
Location: Guatemala (for real)
Lighter bolt (delrin) will make it kick less but might make it less consistent or need to raise LPR pressure, heavier (teflon) will make it kick more than delrin but still less than stock, & it might remain as consistent as the stock bolt.

The only reason I'd change the bolt is to get o'rings on it, if it doesn't have them yet, then again I go for efficiency & consistency over smoothness.

I'd go teflon and get the lightened return spring they also sell. Either one open face with 2 o'rings.

Low blow will do nothing but impair air flow, get open face. As far as detents, I'm not sure that they're exactly the same but you could try timmy detents and clip them if they're too long
tacxplosion is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump