[SmartpartsFusion]

ok so i got my vic from blast last week and when i air it up it has a leak maybe from the engine or the grip frame and body, but after i shoot once its done, it stops until i release the air and air it back up. i went through and lubed everything with dow55 to make sure it was lubed.. any help would be great.


also i have a ul barrel and with the ul i get alot of barrel breaks. its a .688 back. i shoot the same batrel on my ego with no problems same paint help with that will also be great.

[bronze]

what is the output pressure on ur tank, High or low?

whats ur LPR and HPr and dwell?

[XxHeadShotzxX]

Do you feel the air coming out from behind the grip? Like in ur hand?? And answer Bronzes question above too.

[IgnoranceInABag]

fresh battery?

[SmartpartsFusion]

Originally Posted by bronze

what is the output pressure on ur tank, High or low?

whats ur LPR and HPr and dwell?

lp cp tank pushing out 450. lpr 80 hpr 215

Originally Posted by XxHeadShotzxX

Do you feel the air coming out from behind the grip? Like in ur hand?? And answer Bronzes question above too.

its like not extreme and its like in the middle of the actual rubber grip commng out between the grip frame and the body, but u can feed actual air comming out. i was assuming since when u shoot one shot and it stops that its coming from the actual engine somewhere.

Originally Posted by IgnoranceInABag

fresh battery?

yes fresh battery

[XxHeadShotzxX]

yea if its coming out from underneath the grip then its most likely the oring in the ASA, which i had the same problem too......here is my thread with pictures of the oring that may need to be replaced or put back into place.....

http://www.pbnation.com/showthread.p...light=asa+leak

[SmartpartsFusion]

Originally Posted by XxHeadShotzxX

yea if its coming out from underneath the grip then its most likely the oring in the ASA, which i had the same problem too......here is my thread with pictures of the oring that may need to be replaced or put back into place.....

http://www.pbnation.com/showthread.p...light=asa+leak

mine is in between the body and grip frame not the asa

[IgnoranceInABag]

there is a little o-ring inside the frame. on the left side when looking from the back

[SmartpartsFusion]

Originally Posted by IgnoranceInABag

there is a little o-ring inside the frame. on the left side when looking from the back

will that cause it to leak and then when shot stop leaking?

[IgnoranceInABag]

if its leaking from inbetween the frame and body its possible that that o-ring just isnt seated right

[SmartpartsFusion]

ok i put my pressure tester on and it was at 75 lpr dwell at 6 and hpr was only at like 190.. is that ok

[rbueno_01]

Originally Posted by IgnoranceInABag

if its leaking from inbetween the frame and body its possible that that o-ring just isnt seated right

yes check the oring out

[SmartpartsFusion]

Originally Posted by rbueno_01

yes check the oring out

what about pressures?