Originally Posted by Shawn_Savage
Is there a tutorial of sorts that show how to properly mod a winchester with a lid? I have the lid I can use. My other winchester came modded with 2 snaps (holes put through lid and hopper and then the button snap things installed) put through the lid and hopper to secure them together. The lid pulled off though so I believe it was set up incorrectly.
Anyways, I checked the sticky and could only find an expired picture thread about 50 round pods so no help there.
Sorry, I don't know of any tutorials but I remember reading a thread just like this one where someone posted instructions... Just passing on the favor
1. Saw off the lip of the hopper that holds the pringles lid on. Try not to saw off more than necessary.
2. Use some medium grit sandpaper to sand off the cut edge... Hold the sandpaper in place and push the hopper onto it.
3. Wipe with wet paper towel to get rid of crud on the edge
4. Superglue the lid onto the hopper at the angle you want!
Trust me, superglue is tons stronger than any pins. That's really it.. Hope this helps