[juit]

I can make one

if some one can send me a stock pin and a bolt I might do something for all of you

can some one send me a pic of my bolt in the from the top breach area?

please let me know how many are interested!

[tr3b0r]

Saw your post in the other thread, let me see if I have a practice coming up on the 28th and I may be able to mail out my pin after this Sunday.

For the breech pictures, do you want with the bolt forward, pulled back, your pin, stock pin...? I can take whatever pics you want.

Also, the stock pin works with your bolt. I just had to drill out the hole ever so slightly. I can get the bit size I used to pop the stock pin in.

Oh and the detents on this particular marker are rubber finger detents. This means that when the bolt is at rest (forward) the detents are pushed forward at a harsh angle since the detent slots are small and shallow on your bolt.

[juit]

Originally Posted by tr3b0r

Saw your post in the other thread, let me see if I have a practice coming up on the 28th and I may be able to mail out my pin after this Sunday.

For the breech pictures, do you want with the bolt forward, pulled back, your pin, stock pin...? I can take whatever pics you want.

Also, the stock pin works with your bolt. I just had to drill out the hole ever so slightly. I can get the bit size I used to pop the stock pin in.

Oh and the detents on this particular marker are rubber finger detents. This means that when the bolt is at rest (forward) the detents are pushed forward at a harsh angle since the detent slots are small and shallow on your bolt.

bolt all the way back to see hows the breach
Im thinking I'll have to buy one of this markers LOL

[tr3b0r]

I found mine used for $75. Heck, I've got more in upgrades than the cost of the marker: $12 Q-lock feedneck, $20 Etek reg, $30 your bolt and $41 for the Lurker Eigenbarrel.

I'll take off the feedneck and get you some pics here shortly.

[tr3b0r]

Here are the pics with the bolt all the way back to where the striker engages the sear:









The cupped face doesn't sit "flush" with the feedneck when it's pulled all the way back, it's slightly recessed. I actually prefer this if I'm using a grav-fed hopper. There's a little more room for the ball to wiggle into the breech versus just dropping straight down and possible not making it all the way in before the pump stroke finishes.

I'll be testing it out again this Sunday with my repaired sear spring and the stock bolt pin.

[juit]

I can make it a flat face version & no Oring in the tip
did you tried to swap the pin?
or I can send a bolt pin unmachined version too

[tr3b0r]

When I initially tried to swap the pin, the stock pin has a slightly larger diameter and wouldn't fit in the pin hole for your bolt. I couldn't really tell how the grooves matched up since your pin was worn from the retainer pressing against an un-machined spot in order to lock in the pump arm/striker groove.

After slightly drilling out the pin hole, the stock pin fit and worked perfectly with your retaining system. However, I had to make sure that I backed the screw out (a little at a time) so the pin pushed all the way into the body. Any pin sticking out gets caught on the frame and pump arm.

[juit]

Im going to need a stock pin of the azodin
do you have a electronic caliper?

[tr3b0r]

I've been meaning to purchase one. But haven't had enough projects to warrant the cost.

[juit]

Originally Posted by tr3b0r

I've been meaning to purchase one. But haven't had enough projects to warrant the cost.

Me too
right now I have a quest bolt project, this bolt, a new 2 piece protege bolt, have to make more proteges bots and want to create a marker