Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 02-13-2010, 08:06 PM #1
why so much .50 hate?
justanotherPBplayer's Avatar
Join Date: Aug 2009
pgp upgrade

should i consult Palmers Pursuit for a increase of barrel length?
justanotherPBplayer is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 02-17-2010, 10:31 PM #2
Pump Kin
GtrLvr's Avatar
Join Date: Feb 2009
Location: 518 NY
GtrLvr is playing at Living Legends III
Yes, there may be other airsmiths that do it but they would be your best bet. While they have it, you can get them to install one of their dyna valves and wedgits and anything else you may want. Otherwise get your own brass tube and cut and solder it yourself if you have the tools. I could link you to a guy on MCB who sells brass tube if you wanted to go that route.
Rubber Duckies-518th Brigade
Batteries not included

Scenario Paintball TV(SPbTV)-Paintball videos from the Northeast and Europe
GtrLvr is offline   Reply With Quote
Old 02-20-2010, 11:15 AM #3
The Inflicted
.detcilfnI ehT
The Inflicted's Avatar
Join Date: Jan 2002
Location: Nashville, TN
The only thing about Palmer's is that they are extraordinarily expensive.
How longer are you wanting to make your barrel? It might be cheaper just to buy a whole new gun, like a PM-1 or P68SC.

Also, you used to be able to find bolt-on barrel extensions for the PGP. I have no idea how effective these were in actually increasing accuracy or efficiency, but I'm sure one of those would be cheaper than sending the gun to Palmer's for permanent modification.
The Inflicted is offline   Reply With Quote
Old 02-23-2010, 11:46 AM #4
Join Date: Aug 2002
Location: Michigan
 has been a member for 10 years
I bet it would cost less to buy a PMI-1 or P68-SC than to send a PGP to PPS and get a barrel extension.
MrBig is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump