[dankrank]

Hey guys my LPR is having gauge problems... I air it up and everything but the LPR gauge doesn't read anything. I looked at the manual and took the LPR apart. One thing i noticed that was out of the ordinary was that part number 6 in the manual( the LPR washer) was not there. In its place is what looks like the washer without the hole in the middle. Its weird because i haven't had the marker that long and only used it a few times so I hadn't taken the LPR apart yet. Every time i played it worked fine. Now, I can get it to fire and that but the gauge reads well bellow zero and adjusting it does nothing. I'm using a cp on off and a cp shorty reg if that helps. Thanks for your help guys.

[bomb_xero]

your gauge is probably dead.
the washer isnt supposed to have a hole in it so all is normal.

just make sure you arent having the lpr too high. just reset it every time you play.

back lpr all the way out.
while marker is gassed up slowly turn lpr up until marker fully cycles.
give 1/4 turn more for good measure

[dankrank]

so should I buy a new gauge and then try this? Where can I get one?

[Uziel Gal]

Most larger paintball shops are likely to have 1/8NPT threaded microgauges in stock - it's a pretty common item. 300psi ones aren't the most common of them, but it still shouldn't be too hard to fine one.

You can always try www.google.com/products to find one.

[dankrank]

So the gauge was just blown. Ordered a new one from CPS. Thanks Aeron and everyone over there.