Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 06-16-2009, 04:56 PM #1
Gunlex
 
 
Join Date: May 2009
Micro Line fitting leaking??

It appears that I have a leak from where the macro line goes into the fitting, is this possible? And if so, where can I buy another?

-G
Gunlex is offline   Reply With Quote
Old 06-16-2009, 06:15 PM #2
Guess 005
Stage 5.1 Master
 
Guess 005's Avatar
 
Join Date: Jul 2007
Location: *847*Chicago Suburb*847*
Have you tried changing the hose?

Are you sure that it is not where the fitting screws in?

If both above are wrong, www.punisherpb.com or www.smartpartsparts.com should have them.
__________________
Looking For RevolutionTT Invites...PM ME
Guess 005 is offline   Reply With Quote
Old 06-16-2009, 09:36 PM #3
[NA]WARLORD
 
 
[NA]WARLORD's Avatar
 
Join Date: Dec 2001
Location: Sunny FLA !!!!!!!!!!!
[NA]WARLORD is a founding member
 has been a member for 10 years
[NA]WARLORD has achieved Level 2 in PbNation Pursuit
[NA]WARLORD supports Empire
better prices and colored fittings can be found at macrolineguy

Also, have you tried cutting the macro and re-fitting it to the elbow ? I use a razor blade for macro cuts, gives the best cut.
[NA]WARLORD is offline   Reply With Quote
Old 06-16-2009, 10:01 PM #4
Guess 005
Stage 5.1 Master
 
Guess 005's Avatar
 
Join Date: Jul 2007
Location: *847*Chicago Suburb*847*
Are you talking about micro line, as stated in the topic, or macro line.

If its micro line, macrolineguy.com doesnt sell it.
__________________
Looking For RevolutionTT Invites...PM ME
Guess 005 is offline   Reply With Quote
Old 06-17-2009, 07:03 PM #5
Gunlex
 
 
Join Date: May 2009
its the plastic/rubber tubing, I think they're called macro lines?
Gunlex is offline   Reply With Quote
Old 06-17-2009, 07:34 PM #6
Guess 005
Stage 5.1 Master
 
Guess 005's Avatar
 
Join Date: Jul 2007
Location: *847*Chicago Suburb*847*
If its inside the gun, its called microline (the one attached to the board) and the one that attaches your asa to your reg is a macro line.
__________________
Looking For RevolutionTT Invites...PM ME
Guess 005 is offline   Reply With Quote
Old 06-18-2009, 12:56 AM #7
Logan09
 
 
Logan09's Avatar
 
Join Date: Apr 2009
Location: Pella
Logan09 supports Team VICIOUS
Sometimes the fittings dont seal right after a while. I have used teflon tape on the macroline after making a clean cut with a razor. Wind some teflon tape around your macroline tightly and make sure it dont have any in the way of air flow. Your gun wont like that stuff going through it. Snap the macroline back into the fitting tightly, then give it a good pull to make sure it's locked in.


Try that.
Logan09 is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump