Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 06-07-2009, 09:42 PM #1
Tbarbaro85
 
 
Join Date: Jan 2009
what would the be the best settings for blackheart board

trying to find out the best settings for the ion with a l7 bolt and blackheart board because every thing i try waste to much air if some one could help me with all the settings

dwell,rof,debounce and every thing else thank you
Tbarbaro85 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 06-07-2009, 09:59 PM #2
spug
spuggles
 
spug's Avatar
 
Join Date: May 2005
Location: NY
Annual Supporting Member
spug is a Moderator
spug is a Supporting Member
spug is BST Legit
spug donated to help Peyton Trent
spug supports our troops
spug is Legendary
We can't give you a number, as each gun is different.

Quote:
Originally Posted by Kolder View Post
How to set Dwell

  1. Pressurize your Ion at whatever input pressure you wish to use. We suggest between 150-180 psi, depending on the internals. The following steps involve you dry-firing the marker (firing it without paint).
  2. Lower the dwell setting to the minimum (or an extremely low setting, such as 5 blinks with the stock board, or 8 milliseconds with an aftermarket board).
  3. Gradually increase dwell until the marker begins to fully cycle. When the marker has trouble cycling, the sound of the bolt firing will be muffled and sound erratic, denoting inconsistencies. When you reach the point where it fully cycles, the marker will make a loud POP for each shot you take, with minimal sound difference between the shots.
  4. Once the Ion is fully cycling, increase the dwell another 4-6 blinks (2-3 milliseconds with aftermarket board), and that will be your dwell setting.
spug is offline   Reply With Quote
Old 06-07-2009, 10:07 PM #3
DJxContr0lx
Bad Cobra!!!
 
DJxContr0lx's Avatar
 
Join Date: Jun 2007
Location: Smithfield, RI
This is how I have mine set.... I hope it gives you a good start point


Dwell Solid Yellow 20
ROF Solid Red 15
Firing Modes Single Blink Yellow 1
Debounce Single Blink Red 1
BSADouble Blink Yellow 12
Kick-In Rate Adjust Double Blink Red 5
Sustain Rate Adjust Fast Blink Yellow 5
Number of Shots to Enter Firing Mode Fast Blink Red 3
DJxContr0lx is offline   Reply With Quote
Old 06-07-2009, 11:28 PM #4
Tbarbaro85
 
 
Join Date: Jan 2009
thany you i will try that out
Tbarbaro85 is offline   Reply With Quote
Old 06-11-2009, 12:13 AM #5
Tbarbaro85
 
 
Join Date: Jan 2009
the settings did not work will shot once and the drop every thing unless i wait about 30 seconds and then shoot again
Tbarbaro85 is offline   Reply With Quote
Old 06-15-2009, 10:30 AM #6
DJxContr0lx
Bad Cobra!!!
 
DJxContr0lx's Avatar
 
Join Date: Jun 2007
Location: Smithfield, RI
whats your pressure set at?
DJxContr0lx is offline   Reply With Quote
Old 06-15-2009, 01:40 PM #7
that ion owner
 
 
that ion owner's Avatar
 
Join Date: Jan 2009
yeah. raise the dwell.
and clean out your
1.reg
2.tank reg
that ion owner is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump