My E2 screen just went out, and this aint the first time either! I just got it half blocked, mq'd and was finishing up the bolt on the lathe when the screen got all wierd numbers and then went blank....... Tadao here I come!! Thanks for nothin PE
You had the frame on the gun when you were cutting it?
This has been a TEST, This life has been a TEST.
Had this been an Actual LIFE you would had lived in
the Mountains, Never worked and SKIED EVERY DAY
I can say for certain that if you have a working cocker that shoots just fine you are one of the three, or all of the above. 1- you are not an idiot. 2- you know someone who is not an idiot. 3- you have enough money to pay someone who is not an idiot. - jonotwist
LOL yeah I had the block of delrin in the gun while I was using the lathe...... no I would cut then test then recut for the perfect bolt fit and while test firing, I was up to about 15cps, the screen got all funky and went blank. The back light is still lit though... anyone know who the manufacturer of this screen is?????
might just be a connection problem, look around for where the leads from the screen meet the board, there might be something loose. not sure if there's any sort of plug or anything hidden under the attachment point or something. meh, give it a wiggle and see what happens...