Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 01-17-2009, 08:47 AM #1
dudewtf1994's Avatar
Join Date: Nov 2008
Location: The Queen City
noid clicking but not shooting

my marq 6's noid is clicking but when i put air in it it wont shoot help.
dudewtf1994 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 01-17-2009, 09:43 AM #2
< Kris Williams is HOT
stevebski's Avatar
Join Date: Aug 2006
Location: MD
stevebski supports Bob Gurnsey
stevebski supports our troops
does your light stay on when you pull the trigger? If it goes off, it's a bad battery. I'd swap your battery out anyway. Once you get the board to where you can reset it to stock settings, do so. A lot of problems come from people trying to find the magical "perfect" settings that nobody knows about, but in reality the best setting are stock. Check your wiring harness, make sure no wires are cut, pinched, damaged. Is your HPA reg regulated down to where no air is getting through?
Kent Island Sea Monkeys - Semper Gumby
stevebski is offline   Reply With Quote
Old 01-17-2009, 05:46 PM #3
Zeus Dick
AndrewFalk's Avatar
Join Date: Mar 2007
Location: The North East
AndrewFalk plays in the PSP
AndrewFalk plays in the APPA D5 division
Here are some things to check:

Fresh battery.
Dwell @ 8 ms.
Cleaned and lubed engine (o-rings checked for damage).
Make sure your regs are set properly.
Make sure no hoses are pinched.
^Same thing with wires.
Mechanical Engineer - Machinist - Current Civil Engineering student
AndrewFalk is offline   Reply With Quote
Old 01-17-2009, 08:44 PM #4
The All Knowing One
RaymiusII's Avatar
Join Date: Oct 2006
Location: PDX
Annual Supporting Member
Check your LPR pressure also
RaymiusII is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump