[S.O.Ricky]

My Zeus is a warsensor but I was told the E grips from the WG 65 will fit the G2, so does anyone know where I could find one or any other E grips that will fit in the G2.

[Castro #66]

Any Spyder-type frame should work with a little effort.

[Robotech]

You are correct, the WG/WS line of e-triggers will work.

As castro mentioned a e-grip from a Spyder should work too...I think the big thing with those was getting the sear height just right.

The bigger question is...why? It's a pistol...

[Castro #66]

Actually, I wanted to do the same thing for a special project several years ago. However, I bailed on it, since it turned out to be a fancy-looking Spyder.

[S.O.Ricky]

I just wanted to make a cqb marker to replace the A-5 I never use and I decided I would buy a vice instead of an EMAG, so with the left over money I am going to make a woodsball marker with an Egrip just to make the trigger pull a little easier, I also kinda want to get some one to mod a different board in it, and a mod it to give it a better trigger, I have no clue how I would go about it because I dont really know how it works yet
I just want to be able to rock the trigger at maybe a steady 16 BPS, of course I have no clue if it will even cycle that fast, we shall find out
It should be an entertaining project though

[Castro #66]

The gun will work in that rate of fire, though not very well on 12g cartridges. If you'd like someone to build the Zeus up for you like you're talking about, consider my Airsmithing services.

[Robotech]

I know there use to be a constant air kit that you could get for the Zues that would let you get away from 12 grams. You may want to look for that as well. Looks like Warsensor still makes them:
http://www.buypblusa.com/cgi-bin/zco...equipement=135

Then you may also need a hopper adaptor. There are two:
http://www.buypblusa.com/cgi-bin/zco...quipement=1877
http://www.buypblusa.com/cgi-bin/zco...equipement=133

Not sure what the difference is between the two. Castro is right though, at that point in time you have a very short Spyder. That would be a start. Then you just need to find your E-trigger.

Or you could do what I did to my A5:


By my Warsensor and Miltec markers for size reference:


Of course, the drawback to this setup so far has proven to be velocity. Right now it can only achieve about 210 FPS. I haven't yet put shims behind the spring or installed a firmer spring to try and get it higher than that. I imagine if I had the 3" barrel that wasn't ported I would have an easier time of it as well. But if you're going close quarters 210 fps has been enough for me.

[S.O.Ricky]

I have a bottom line for the pistol, and will be getting the hopper adapter soon, I think I will find someone on M.carter brown to deal with the e trigger.
Does anyone know if the armotech e grip is activated with a microswitch?