Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 11-17-2008, 09:14 AM #1
Golumbo
Canadian
 
Join Date: Jun 2007
Location: Newfoundland, Canada
Golumbo supports Cereal Killerz 2
Question for BL tech/machinist

Hey thurr,

I called BLAST a few weeks ago, intending to ask about this problem, but it wasn't too pressing at the time and I ended up just getting a replacement feedneck ring (which they didn't have in stock anyways haha), but I figured it would be easier to post it up here.

Here is an attempt at a diagram of the feedneck without the ring on (I don't have access to a digital camera right now haha):
v
_____
| -- ' <
| |__
'--------------REST OF BODY (BACK) hmmm not a shabby job haha

Where the "v" and "<" is pointing, is bent. Slightly.

I didn't do this; the previous owner had a BL clamping feedneck on it (one of the big mother****ers), and when I took it off, the feedneck was like this.

From the top, it's barely noticeable, but you can't fit a normal Halo inside the feedneck at all. My Vlocity BARELY fits, but it stays tight when I fit it in.

I don't even HAVE a feedneck ring right now, but the gun functions normally without it.

This is irritating me, however, and I was wondering if BLAST had a dremel with a tough enough bit to smooth this thing out, or any other solution?

Thanks in advance!
-Kevin
Golumbo is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 11-17-2008, 05:03 PM #2
tokay444
Dust white Darq Marq user
 
tokay444's Avatar
 
Join Date: May 2008
Location: Oakville ON. Canada.
it's aluminum. bend it back.
tokay444 is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump