[wanna-b-ballin']

i'm talking about the simple black ones that came stock on pretty much all the older cockers, that had the air line run up directly into the center of the bottom.

i turned my cocker to pump, except my velocity is way way to high and the ivg is backed out all the way.

i noticed in my reg that when i remove the macro fitting, there is a slot for a flathead screwdriver inside, and i was wondering what way to turn this to lower my velocity.

[hmcl281]

should be counter clockwise to lower

[russc]

If your velocity is too high you should be getting a weaker spring, that way you get to use your valve at peak pressure and reduce dwell. You can also clip a couple rings from the spring.

[wanna-b-ballin']

yeah i'v got some work to do.

i dove into snake and shortly afterward i cocked my sniper and my gun twisted sideways on the gripframe. friggin stripped the rear frame screw threads out of the body.
i need a spring kit, but i dont have a valve tool.


and i tinkered with it. screwing it in lowers the velocity and backing it out raises the velocity.