· To adjust any of the settings on the circuit board, you must remove the left side of the grips (or the entire grips, it doesn't matter) and push the programming button once.
· There are two additional LEDs located under the grips as well (yellow and red). When you enter programming mode, one of the LEDs will light up, signifying you're in programming mode.
· Pushing the programming button will cycle through the six adjustment modes, each with its own LED color/pattern:
Solid yellow - Dwell up
Solid red - Dwell down
Single blink yellow - Recharge up
Single blink red - Recharge down
Double blink yellow - Fire mode up
Double blink red - Fire mode down
Here for all your Board needs.....
Ion board and Eos board have the same settings.