I just recently acquired a Proficiency kit for my Marq6 with Tadao Ryujin, I have it set up and working. Something seems "off"...
LPR ~ 55psi
HPR ~ 225psi
Am I doing something not right here?
I have tried setting hpr lower, lpr lower, dwell lower in various combinations... nothing seems to work much better. From all the settings I have found everyone seems able to run lower HPR and lower dwell... some people seem to have a lower lpr too.
DO NOT TELL ME TO READ THE STICKIES. I HAVE READ THEM 142598745 TIMES.
It's only bad if you can't get it higher. If your field allows a higher velocity than raise it. One of my local fields has a limit of 280 fps for walk-on so 275 fps is ideal if it can be maintained consistently.
For Sale: Cheetah 10.2 HALO board-DM6 with upgrades Some Invaluable Words of Wisdom: A wise man's heart directs him toward the right, but the foolish man's heart directs him toward the left. -Ecclesiastes 10:2 “If you're not a liberal at twenty you have no heart; if you're not a conservative at forty you have no brain.” -Sir Winston Churchill "Lousy Democrats."-Homer J. Simpson
Last edited by AlmightyRuler : 08-10-2008 at 06:38 PM.
thanks guys. I am going to try lpr of 65... I cant get more than 275fps right now, our field allows 300... I suppose I could try to up the hpr a bit more, however, I dont really know what the noids max is, dont really want to push it too hard.
My Closer settings with Proficience Engine now are
LPR - 70 psi
HPR - 212 psi
dwell - 8 (Tadao Ryujin)
I just installed it and it seems quite inconsistent (or probably paintballs were not so good) and velocity was about 290 fps
With LPR 50 psi I couldn't get velocity more than 230 fps
My closer settings with the new engine were:
I couldnt get the fps above 220
I bumped the hpr up to about 210
I bumped the lpr up to about 65
the dwell was at 10 still
It was shooting 290s but it kicked and was as loud as a tippman i think something is wrong with my engine and very inconsistent