Now this is strange....help needed
Was going through and getting my gear ready for tomorrow. I always clan my gear after I play and also give everything a run-through before I pack my gearbag back up. So I aired up the Legend and filled the loader with some zballs to make sure everything was working fine and velocity was on point. It will not shoot and actually turns itself off. here is what happens:
***NOTE: Tadao Board Installed***
Gun turns on and blinks green showing good battery before turning into a blinking blue(blinking blue means no ball in breach)
I put a zBall into breach and led turns solid blue(this states gun is ready to fire)
Pull the trigger, nothing happens and the LED goes off.
I tried this a few times same result and I actually have to hold the button to turn gun back on. I tried turning it on then switching to dry-fire setting and it does same thing. However if I turn on and do not put anything in the breach(blinking blue) and pull trigger it stays on, but once it is solid blue(rdy to fire) after first trigger pull, goes off.
Here is what I have already done:
-New batterys(I used a fresh rechargeable and even a brand new 9volt)
-Different tanks(both were at roughly 35k fill and worked fin when testing my EGO6 earlier)
-When tanks screw in and I turn ASA on, you can hear it airing up properly
Any ideas guys?