Originally Posted by EgoManiacal
Lubed everything properly? connected all the hoses correctly? Sounds like the noid isn't getting air to the front of your bolt or the bolt is sticking... Did you try taking a few clearing shots?
Swapped the stock can and bolt and shoots fine.. emailed their support, all they said was try different seals. Relubed the heck out of it, replaced the brand new seals with more brand new seals.. you can't fire it, it blows air straight out.. this is not a slow leak, this is as if there was no bolt and just blowing air. The bolt moves forward when aired up, not back. I have wasted at least one tank jacking with it.. switched back to stock and put this bolt away for now.. no issues running stock bolt.. and yes I tried the pressure at different levels 200, 220, 240, 260.. and I am putting the bolt plug in and have a good seal on it. I am sure it is something dumb, but after 5 or 6 tries, it's not obvious what it might be. This bolt has no seals on the shaft (other than barrel end) and the front of the can (inside, not the one on the outside) has a groove where it appears a seal might go, but there is not a seal