So I recently picked up a ND shocker and I'm having two problems.
1. I have a virtue redefined board in it but it seems to be shooting when the eyes are on even when there isn't paint in the chamber.
2. There seems to be a leak coming from the bottom of the reg when it sits for a few moments.
Leak from the bottom of the vertical regulator (adjustment endcap).*Leaks out the adjustment endcap can appear gradually after you fire a shot or be a constant leak of pressure. Same problem for both of these. The following seals can cause this symptom, and should be cleaned.*·*Base seal between the poppet and the base (flared section of the poppet and the opposing surface); clean with no grease.*·*Piston o-ring (14/75); clean and regrease.*·*Base seal 12/90 o-ring within the regulator housing (unlikely but possible); clean with no grease.
Well I went to air up my gun to show a friend of mine the problem and the leaking went away. Now all I have to do is drill an tap a ccm frame that came with it to accept different grips. Any suggestions on comfy grips?