Virtue Board (what to do next)

klandry(speed)x · 12-01-2007, 03:41 PM

ok so i just put in the virtue board in my ion. it rapes.. what do i do next, just leave it how it came or do some tweaking. i dont have a qev in yet but thatl change soon. what advice can anyone say about tweaking the board more so it shoots faster, better, less air etc-thanks

AnonymousTPT Ian (Banned) · 12-01-2007, 08:17 PM

I know you can lower the dwell a bit but do what you want it's your stuff.

AlmightyRuler · 12-01-2007, 08:33 PM

A QEV would increase your cycle rate significantly. As far as tweaking, Virtue will make that much easier. What are your settings now? I would figure stock, I just don't know what they are for the Ion.

You should also take the cold weather into account. Colder weather requires a higher dwell for ideal performance. This is even more evident with spool vavles .

justavillain · 12-01-2007, 08:38 PM

all I did on my PM6 was turn my dwell down, and my AMB up 1 and after that I only changed my firing mode.

ICEMAN09 · 12-01-2007, 10:45 PM

yea my advice too lower the dwell nd get a qev kit.....

klandry(speed)x · 12-02-2007, 12:14 PM

so lower the dwell when the qev is in and higher it in the cold.. how much and how can i lower the dwell on virtue it didnt come with a manual..all i did was installed it so im guessing its stock settings