Now a days I found myself to have a lot of time on my hand so I started to do my first project. It is putting a 06 ego frame and aftermarket board on a pmr. The frame was going to be used for a shego project but then I said **** it and started this because I couldnt wait a day longer to get the parts.
PICS OF PROGRESS:
Started with a blue pmr with a few ups as pictured below:
First night: trying on the frame
Pics before cutting: shows more what it will look like
Done cutting might do a bit more sanding to get it smooth.
How to do this:
Step 1) You need to have a pmr body with internals, ego frame, ego board,ego grips, files, dremel, sandpaper, and snacks to get you through it.
Step 2) Take out all magnet and screw of the frame. Then File or dremel the front of the frame where the front screw goes in and make it flat so the whole front part is flat.
Step 3) Sand it down and try to keep it as flat as possible then see if the frame fit with the solenoid on the body. If it does measure where the backscrew it. Remember measure twice drill once.
Step 4) Go to home depot and buy a longer screw that will fit in there since the one eit comes with will not fit.
Step 5) Ego board should hook right up and you are almost done all you need to do is make eyes for it and set up the board to your liking.
more steps to come
MORE TO COME