Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 11-04-2007, 04:22 PM #1
Stayhuge's Avatar
Join Date: Jul 2007
Location: NY
Pneumag Problems!!! Please Help!!

Hey everyone, I just had a chance to put together my pneumag. I am having problems with the MSV-2, I think(It's the 3 way that the trigger pushes.) anyway, When I air it up, and pull the trigger, it shoots. But it won't shoot again. I tried disconnecting the piston section, to see if it had to do with that, so I figured that when I pull the trigger, the air should go through since there is nothing on the other end to jam it up, but nothing happened. Then I disconnected the hose from the LPR and tried two things, one: I truned the air on, and there was air coming from the LPR, which means that that is feeding air. Then I tried blowing into the air in side of the MSV-2, and pushed the trigger arm. air went through fine. I need help!!! Has this ever happened to anyone? I should also say that I tried adjusting the LPR starting at the lowest level, and slowly increasing it. That didn't work either. I did buy the parts used, so is there a chance that the MSV-2 is busted? I didn't think it was, because it seemed to function properly when I blew into it with my mouth. Any advice is greatly appreciated. THanks everyone.
Stayhuge is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 11-04-2007, 08:48 PM #2
cioeboy's Avatar
Join Date: Jun 2005
Location: Chicago Subs
 has been a member for 10 years
is the arm blocked by anything or rubbing the inside of the frame?
NIU Paintball
cioeboy is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump