[Jamescoop]

yea well, i love my pgp but its getting worn, so im thinking of stuff to do to it.

First i think im going to make it semi auto i think i will mount a cocker 4 way in the grip frame undee teh sear so when i pull the trigger it closes teh valve, however the hoses will be switched so it will actually open the valve to the ram. then ill solder on a prat with the ram thread on it so i can use different rams, and then ill tap the side of the body for the regulator. Any comments/ideas??


also wanted to mill the fed tube so that i could put a spring and lever in to force fed the balls. any ideas/comments?

also, post what u have or what u are ging to do to ur PGP

[Jamescoop]

o yea, how would i make an actual Bolt for it? i want to make it very accurate and im thinking a venturi style bolt, but the only problem is that my stock bolt is jsut a ball thing, the air comes frmo underneath the ball to shoot it out.

any comments/suggestions? how is the cooper-t better bolt?

[Punsher]

but you're on the right track.
Use the bolt you have, it works just fine.
Running the 4-way from the sear is a pain and very hard to time, I'd say you're better off running the 4-way in a more conventional method.
Good luck

[Skyssx]

You can't venturi bolt a pgp unless you move the feed port, or make one with a sliding pump lug that has an extra half inch of travel. Either way is not a pretty solution. Besides, venturi bolts do NOTHING for accuracy anyways.

[Jamescoop]

well i believe that they do, and its personal preference. i know i would havta get a longer pump arm.

punsher- would a cocker stock frame work if i put the four way behing the plate and then reversed the hoses?

[Punisher's Customs]

Yeah, if you mill the cocker frame adn trigger to fit the Pgp body, then you can mount your 4-way to the exterior.....
I've done a couple that way....