Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 10-02-2007, 12:21 PM #1
zeroten
PBN is a waste of time.
 
zeroten's Avatar
 
Join Date: Dec 2005
Location: San Diego, CA
zeroten is a Supporting Member
Slow recharge- SCM III

Here's my setup-

04 vike/ SCM III/ Sidewinder/ Guerrilla Air HP

SCMIII set at 75 psi with gauge.

Here's the deal, with test gauge in marker, single shots quickly recharge back to 68 -70 psi and then creep up to 75 psi where its supposed to be. Rapid fire, the gauge is reading somewhere in the low to mid 60's, stop shooting and it recharges as per first sentence. gun is clean and lubed before and after shooting.

when shooting 5-6 consecutive shots there is minor shoot down.

any advice would be greatly appreciated.

Last edited by zeroten : 10-02-2007 at 03:02 PM. Reason: redundancy
zeroten is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 10-02-2007, 12:32 PM #2
Wizardry
Oldest AKA GunWhore
 
Join Date: May 2001
Location: Florida
Wizardry is a founding member
 has been a member for 10 years
Open up the SCM and remove the largest "O" ring. Replace the "O" ring with a slightly larger one. You can use one from your tank (tank "O"). Before placing the "O" ring in the SCM either put Dow 33 grease or thermal grease on it for lubrication. Put the SCM back together and place your air guage in the marker. Vary your pressure and shoot the marker. Find the optimal setting for the pressure which limits the creep.

Wiz
Wizardry is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump